4/26 · Why do this and not use normal Development times with inversions every minute. There are some very good reasons. 1/ Very economical as highly diluted developer is used in the range of 3.5 mls to 6 mls of developer is used. 2/ Stop bath is not required turning it to a two bath process. 3/Because you let the developer sit (stand) in one position

2022/9/10 · Reply Marco Andrés September 10, 2022 at 3:55 pm Atmospheric images. Semi-stand«offering » Just in time for the recent heat wave in California [40ºC], with tap water over 25c. Tried Massive DevChart (Rodinal 1+100, 80 minutes @21 with far too many

Instructions are for 2 rolls of film. Preparation Mix 10mL of Rodinal with 1L of room temperature water Mix 16mL of Kodak stop bath solution with 1L of room temperature water Mix 1L of 1+4 Ilford Rapid Fixer. This can be reused multiple times! Development 17 minute 30 second duration measured from first contact of Developer to film at 23°C

Tag Archives: Rodinal semi stand Uprating, developing methods compared. 18 Replies Many, many years ago I experimented with uprating HP5, I was a student and it fitted the look I was

Then there is Semi Stand development where the film is agitated for the first 30 sec then left to develop for 20/30 minutes then 2/3 

Stand developing with Rodinal will decrease the contrast, as the developer exhausts itself in the highlights, and has extra time to find developable grains in the shadows. It's a technique that can bring a lot of detail out of images that have been pushed 2 or more stops above their box speed.

Rodinal/Xtol Semi-Stand Development I just ran three rolls of 35mm TMY-2 (rated @ 640) and one roll of Tri-X (rated @ 400) and I'm really 

The images that you see on this page were all developed in the same tank at the same time using Rodinal and Stand Development (technically I used semi-stand but I'll get to that) and came from two rolls of film, Ilford Delta 400, and Kodak Tri-X 400. The entire roll of Ilford was shot in about 30 minutes during sunny day in Onancock, VA.

Relating that to film, during stand development the Rodinal will exhausts itself in areas which require greater development whilst remaining active in less-exposed areas, which has the effect of boosting shadow detail whilst preserving bright highlights. Through stand development, your result is a drastically compressed tonal range.

5/26 · THE MORTENSEN METHOD. Dilute ID11 stock at 1+3. Get the temperature to 20ºC. Pour into the tank, start clock and agitate for 30 seconds. Agitate three gentle inversions each 30 seconds for the first ten minutes. Leave standing, untouched for 50 minutes. Agitate every minute for the next ten minutes. Stop and fix.

Stand Development - Ode to Rodinal · Pour in the chemicals · Tap the tank against the table to dislodge air bubbles. · For the first five minutes