Alloy Steel Toggle Plate, For Jaw Crusher Machine Product Type: Jaw Crusher Spare Part. Set Contains: 2. read more Drashti Casting & Forging.

A toggle plate and tension rods hold the pitman tight near the bottom of the moving swing jaw. The toggle plate is designed to perform like a fuse and protect 

Creative Jaw crushers are extremely heavy duty machines and hence robustly constructed Creative s range of single toggle jaw crushers are designed with an 

Toggle plate is an important spare parts of jaw crusher, It is designed to shear protecting crusher components if non-crushable object is introduced to crusher; Jaw plate's high manganese steel castings can be reversed allowing extended life.

If something that the jaw crusher cannot crush gets into the crushing chamber accidentally and it cannot pass through the jaw, the toggle plate will crush and prevent the whole machine from further damage. Minimal maintenance requirements. Inquiry This Item Looking for aftermarket parts? +86 159 5822 9409 / +86 138 6784 5744 [email protected]

Toggle Plate is a simple & low-cost but very important part of jaw crusher. It is usually made of cast iron, and it is used to hold the lower part of the jaw in position, it also serves as a safety

The material of toggle plate is high manganese, good performance with low abrasion, high resistance., Jaw crusher parts is widely applied in mining, metallurgy, construction, road building, chemical and phosphatic industry, and is suitable for hard and mid-hard rocks and ores.

3/19 · Design of Toggle Plate In Jaw Crusher 03/19/ 2:22 PM I have a plan to design a new model Toggle plate that helps to perform the crushing operation easily with less power conception. I have the Solidworks software for it. need advice.. Register to

8/9 · What Are the Functions of Toggle Plate of Jaw Crusher? -08-09 09:08:35. Toggle plate is the most simple and low-cost part of Jaw Crusher, which is usually made by

The toggle plate of the jaw crusher was supposed to break when uncrushable material passed through the crusher. The toggle plate did not break and did not act as a safety device. The crew tried to dislodge the rock with a backhoe tooth cut from another piece of equipment and attached to a chain. The tooth then became wedged into the lower end

Typically, the bottom of the pitman is supported by a piece of metal called the toggle plate. It serves the purpose of allowing, within limits, the bottom of the pitman to move up and down with the