Two ferrule compression tube fittings are manufactured under strict quality control program and close tolerances. There is no international / national standard 

Tube Fitting Catalog, v Available in tube sizes from 1/16 in. to 2 in. & 2mm to 50 mm. v Easy to disconnect and retighten. v Wide variety of materials and configurations. www.tubefiteng.com, ENGINEERS, Tube Fitting, Tubefit Tubefit, Tubefit, Tub ef i t, Tubefit T u e b fi t, Tubefit T u b e fi t, T u e b fi t Tub efi t T u b e f i t, Contents 0,

The tube dimensions define the difference between tube and pipe, with wall thickness of pipe being greater than that of tube for the same outside diameter. Also tube products are defined by their outside diameter measurement, while pipe is measured by the nominal inside diameter (ie Nominal Bore, NB) and the Schedule (wall thicknesses).

Tube Fitting Catalog v Available in tube sizes from 1/16 in. to 2 in. & 2mm to 50 mm. v Easy to disconnect and retighten. v Wide variety of materials and configurations. www.tubefiteng.com

In another example, a -10 tube would indicate a tube with an outside diameter of 10/16", or 5/8". Fittings are a little different and slightly more complex. In the part number 10343-8-6, for example, -8 is the size of the fitting end connection, and -6 is the hose size.

Universal-Thread Nickel-Plated BrassPush-to-Connect Tube Fittings for Air and Water. Made of nickel-plated brass, these tube fittings resist corrosion better than plain brass fittings. The male threaded ends connect to NPT, NPTF, BSPP, BSPT, and other universal threads, so you don't have to bother matching exact thread types.

8/26 · 37 degree jic flare fitting dimensions including Male flare tube end and swivel flare end, whatever parker 37 deg flare fittings and others, all is made acc to mil-dtl-18866, SAE J514 and ISO 8434-2. Male JIC flare fitting dimension SAE J514/ISO 8434-2 as

From the above table, you can see that for NPS 2, Pipe ID is near to pipe NPS, and for NPS 14, pipe OD is the same as NPS. 4″ sch 80 pipe schedule You can easily convert inch dimension to mm by multiplying it by 25.4 and rounding as follow; Outside diameter above 16 inches rounded to nearest 1 mm

I-Line Fitting Dimensions I-Line Fittings can be measured by different locations on the fitting in order to determine size. As you can see with the line drawing for a Male I-Line Ferrule below, you can measure the following locations to determine the size of your fitting. Outside Diameter of Flange Outside Diameter of Tube End

Gaugeable Tube Fittings and Adapter Fittings Features: Available in sizes from 1/16 to 2 in. and 2 to 50 mm; consistent gaugeability upon initial installation; easy to disconnect and tighten; wide variety of materials and configurations

Browse Victaulic pipe fittings, adapters & outlets in stainless steel, copper, HDPE, PVC/CPVC & more materials. Various size & pressure ranges available Accommodating pipe pressure ranging from 0 to 4000 PSI/276 Bar and pipe sizes of from ¼" to 60"/ DN20 to DN1500 Victaulic's pipe fitting products can meet the requirements of