5): Plummer block housings SN3028, SN3126, SN524, SN620 and larger are provided with eye bolts. (6): When one locating ring is used for fixed-end, the offset (X dimension) of bearing center from the center of the plummer block housing is a half of the locating ring width.

Split Pillow Blocks/Plummer Blocks. Some sizes of housings listed in this catalog may not be available. SN500-600 Series. SN200-300 Series. SN3000 Series.

Timken® SNT split plummer blocks are available with multiple sealing options. Each seal type incorporates specific features to meet your application needs. The table on the following page compares the various features of each seal type. DOUBLE-LIP SEALS (TSNG) Double-lip seals are the most common seal design used with SNT split plummer blocks.

This catalogue contains split and unsplit plummer block housings as well as take-up housings and flanged housings. In addition,.

housing units. Further information. □ Catalogue GK 1, Bearing Housings https://www.schaeffler.de/std/1F7F.

The bearings are either directly seated on the shaft or fixed with adapter sleeves. This results in different shaft diameters for the same bearing size.

Plummer Blocks (Bearing housings) Series SNV for bearings with adapter sleeves Plummer Block Designation SNV 52 SW 62 SNV 72 SNV 80 SW 85 SNV 90 SNV 100 58 Shaft dia da mm 20 25 20 30 25 35 30 40 45 35 50 40 A 77 82 85 85 90 95 Al 46 52 52 60 60 60 70 31.5 36.5 46.5 51.5 56.5 62 H 71 89 93 107 109 113 127 DIMENSION IN MM Bearing with

Selection Chart For Plummer Blocks MASTA PLUMMER BLOCKS are available in all sizes starting from 20mm to 500mm PLUMMER BLOCKS SUITABLE FOR BEARINGS.

Plummer Blocks ( Bearing housings ) Plummer Block SN-524 and above are Series SN 500 for bearings with adapter sleeves. supplied with eye bolt on cap mm inch L H A B E V S Ca N N1 SN 518 80 --- 145 100 345 100 290 35 20 62 27 22 1218 K + H 218 16.2/160 2 FS 330 2218 K + H 318 11.2/160 2 22218CK + H 318 11.2/160 2

3 manufacturer. Also, some housings have lube drain holes at the base of the housing. Note the location, if any, to ensure the housing is positioned to allow access, if needed, for the application.

In the fixed plummer block, to prevent axial displacement of the bearing, 2 locating rings are installed, one on either side of the bearing. Locating rings are manufactured in aluminium. Fig.2: One bearing should be free to move axially. This plummer block should