The size reduction takes place in the volume between crushing liners; the mantle movement exposes feed material to the successive compression 

Although it is known for its ability to crush hard and abrasive ores and rocks, the cone crusher is better suited for secondary crushing. It is designed to crush pre-dimensioned materials, generally of 100 mm, 150 mm or 200 mm, and provide finished products of small dimensions. Advantages: Sturdy construction High productivity Easy adjustment

Sepor's Laboratory Cone Crushers are small capacity cone crushers that will reduce 1/2″ and smaller material to -10 mesh in a single pass. Typical capacities 

07/04/  · This is discussed in more detail in the 12 tips to maximize cone crusher productivity blog post. Summarizing, larger setting → product size increases, capacity increases, power draw decreases. Example: The HP crusher chamber selection table shows the minimum opening settings. However, the presented settings are provided as a guide only.

The material you feed into the machine must be pre-dimensioned to the crusher. Most cone crushers have a feed opening size of 5-14", so material 

To complete jaw crusher liner replacement should to avoid damage in cutting cone plate process when the cone lining plate installed the adjustment ring cone at the lower part of the lower lining keep the gap between 1 2 mm between the plate and the cone lining the top installed should be first nut is installed and then cast zinc alloy.

Cone crushers are only altered in the space between the mantle and side. These settings are called the OSS (open side setting) and CSS (closed side setting.) The gap on the side that is open determines the size of the largest particle of the finished product.

The cone crusher’s optimised speed and improved crushing chamber design provides high productivity with less we parts, meaning a great savings in labour. The adjustable crushing chamber can provide the required size of material, and is able to meet a variety of customer needs. AUTOMATION SYSTEM

07/03/2022 · Essentially, material is reduced in size by squeezing the material until it breaks. Specifically, the material is compressed between a moving piece of steel, the mantle, and a stationary piece of steel, the bowl liner. The final product’s size is determined by the closed-side gap setting between the two crushing members at the bottom.

The two cones of the cone crusher are both gently inclined upright truncated cones, and in order to control the particle size of the discharged products, a parallel crushing area is set in the lower part of the crushing cavity, which results in different shapes of the crushing cavity.

Try to direct the incoming feed material so that it is distributed vertically into the center of the crusher. This will ensure that all sides of