Other reasons for high pressure are that your filtration system is trying to filter more water than it can handle or that there is a suction air leak. High pressure in your swimming pool means
Learn MoreCheck your power source. Heat pump owners often forget to perform this simple check and jump right to more tedious ones. Make sure your breaker has not tripped and that the disconnect switch of your heat pump (located adjacent to your unit, typically on a wall or a post) is turned on. Ensure that your heat pump is getting sufficient water flow.
Learn MoreLo / FLO · Check for, and clear out any blockage in the baskets (pump, skimmer) and filter system · Call pool heating to inspect the water pressure sensor
Learn MoreThe swimming pool heat pump must be installed by a qualified electrician. The high-pressure switch senses the refrigerant pressure in the sealed
Learn MoreInternal safety devices may deactivate the heat pump with the following errors: ○. HIGH PRESSURE FAULT. ○. HP5 SYSTEM LOCKOUT. ○. LOW PRESSURE FAULT.
Learn MoreIf not, it could cause an injury due to the high speed running fan or an electrical shock. Do not continue to run the unit when there is something wrong or
Learn MoreThank you for deciding on an open-air swimming pool heat pump from SET The yellow icons LP or HP then indicate a low pressure or high pressure fault.
Learn More17/07/ · In ground pool Aqua Comfort Heat Pump throwing an HP code (high pressure switch open). I have cleaned the cell with mixture of acid and water and the flow of water to the heater is fine. Says the other possibility is a defective high-pressure switch. Is it easy to find one of those and easy to replace?
Learn MoreThe heat pump high pressure switch has cut off three (3) times in the same hour for one of the reasons above. What to do: The heat pump will not re-start after one of the protective devices
Learn MoreThe water flow inside the heat pump is insufficient There is no water circulation inside the heat pump The flow switch is defective: Make sure the circulating pump works; Make sure the bypass valves are properly positioned; Check the skimmer (no obstruction); Check the water pressure gauge of the heat pump, it should read between 10 and 15 psi
Learn MoreHigh pressure error. EE01. 1. Too much refrigerant,. 2. Too high water or environment temperature,. 3. Operating frequency is too high,. 4. Motor
Learn More