Small-diameter holes are created using the technology of deep (gun-drill tool) drilling with the STS (single-tube system). An alternative to STS technology in 

1. Turning Calculators 2. Milling Calculators 3. Drilling Calculators 4. Gun drilling Calculator 5. Thread Calculators 6. True Position Calculator 7. Bolt Pattern Calculator 8. Surface Finish Calculators 9. Drill & Tap charts 10. Thread Pitch charts 11. Center drill data 12. Unit converters 13. Hardness conversions 14. G-codes 15. M-codes 16.

DRILLING TOOL LIST - Indexable drill from large diameter to small diameter, Solid drill, Brazed gun drill with short delivery!

Enter the No. of Teeth and the Chip Load per Tooth to Determine the Feed Rate (In./Min.) Use .002-.005 as starting chip load per tooth Chip Load

Speeds and feeds are based off of x3, x5, x7 drill lengths only utilizing flood coolant or coolant through where capable. Results *Recommended "Chimp" Loads *RPM SFM IPM IPR Cycle Time Per Hole (In Seconds) *The RPM and Chip Load that automatically populates in this calculator are the factory suggested parameters for running the desired tool.

Cutting speed. 90 m/min. 70 m/min. 110 m/min. 70 m/min. Feed f Even higher cutting speeds are possible compared to the gundrill with brazed carbide tip 

Recommended Drilling - Speeds and Feeds. MATERIAL GROUP. SURFACE SPEED. METRES/MIN. FEED RANGE (mm) PER REVOLUTION. DRILL DIAMETER. 1.5mm 3mm.

The Speeds and Feeds Calculator uses the following formulas: RPM = (12 * Surface Speed) / (PI * Tool Diameter) [revs/min] Feed Rate = RPM * Chip Load * Number of Teeth (Flutes) [in/min]

How do you calculate speed and feed? Speed (RPM) = (Surface Feet per Minute x 3.82) / Diameter of the Tool Feed Rate = RPM x Chip Load x Number of Teeth RPM = Of the tool or

The RPM calculated in the Drilling Speed and Feed Calculator refers to the spindle speed in drilling process, and the IPM refers to feed rate. The exact RPM is not always needed, the following calculator (formula) may be used to estimate the value closely. Cutting speed (SFM): the rate at the workpiece surface, measured in surface feet per

NOSEGRIND General purpose stock drill grind for steel. inconel and stainless steel, most often used with stock 'RI' O D. diameter, NOSEGRIND For applications requiring nearly nat bottoms. It can also grind for a completely nat bottom. On difficult materials, use to qualify bottoms only. Dia 0.055- 0.078- 0.156- 0.250-