Conforms to BS3673 Part 2 and DIN 6799, the most common form of radially fitted circlip to shafts with grooves. Nominal size is the groove diameter (not the 

Standard Internal Circlips: DIN 472 Metric Most sizes over 170mm are without lugs Measurements in mm & kN Key to table headings and abbreviations Bore B Circlip Dimensions Groove Dimensions t Tol D Tol Cb b L h Fr kN G Tol W n Fr kN 55 2.00 +0.00 -0.07 59

Stainless External Circlip Dimensions | Anzor Fasteners - Your Stainless Fastener Specialist | Call us - 07 3711 9977 or email us [email protected]

There's two easy methods when it comes to measure External Circlips. External Circlips are always listed by shaft size. For example if you have a 30mm shaft you will need a 30mm External Circlip. Or, if you have an existing External Circlip to hand, simply measure the OUTSIDE edge of one side, to the INSIDE edge of the opposite side.

When measuring the size of an external circlip, you should measure the nominal size of the groove diameter. Do not measure the shaft diameter as this will 

To measure a circlip whether its External or Internal you would measure from the Outside on One side to the Inside on the Other across the widest point on the 

1/29 · Internal Circlips are designed specifically to fit on to bores with grooves. Read on to find out the easy way to measure Internal Circlips! Internal Circlips are always listed by the

g-Gap Size t-Thickness G-Groove Diameter Tol-Tolerance h-Hole Diameter W-Groove Width file:///C|/Documents and Settings/Adam Parker/Desktop/Standard External Circlips DIN 471 Metric.htm (1 of 6)18/12/2005 13:09:23 18/12/2005 13:09:23. Standard External Circlips: DIN 471 Metric Most sizes over 170mm are without lugs Measurements in mm & kN

Justin from MAHLE Motorsports goes over the different types of circlips/retaining clips and explains the theories behind proper design.

Squeeze the handles to close the circlip plier handles and abridge the circlip to the desired size, Guide the ring into the circlip rut and release the pliers, once again, it is crucial to take the smooth and uncut sides of the circlip into account when completing the installation.

Put your finger right next to the clip to grab it firmly as you move. Place the index finger of your non-dominant hand on top of the clip. This will prevent the e-clip from flying too far when you remove it. Using moderate pressure, push the screwdriver upward. Grasp the screwdriver with your dominant hand and continue to push the tool up.